Silhouette Blade Cutting Through Vinyl Backing

How to stop cutting through vinyl backing.

Silhouette blade cutting through vinyl backing.

1 blade is not properly inserted and or locked down. I sure hope it works. My friend and fellow instructor elly from silhouette secrets has diagnosed this issue so often on facebook that she keeps a photo of a properly installed blade on hand to post whenever someone is having cutting issues. Did it cut cleanly through the vinyl.

Blade ratchet to change blade setting on each machine made in the last 3 years or so there is a round indentation on the machine in the lower left hand side. The same goes for the portrait 2 autoblade. This is a tool you can use to change the setting on the blade. When cutting adhesive vinyl or heat transfer vinyl a kiss cut is used to cut the vinyl but leave the carrier sheet or backing intact.

The end cap unscrews while it s cutting it won t automatically set itself to the cut settings in the send menu etc. It took me a long time to get it right and i often have to make small adjustments for various reasons ie. To cut properly the blade must be pushed all the way down with no visible gap between the tool holder and the blade. If you ve just replaced your blade and are having this problem you probably have the wrong blade.

Just remove the blade from the carriage put it blade side down into the indention and turn until the blade is on the setting you want. I can use an older style ratchet blade in the adapter and it will cut fine. Once the cut is finished use the unload button on your machine to unload your vinyl. If your cricut cuts through the backing there are usually one of two possible issues.

If this happened the blade is cutting too deep. One of the most common issues from silhouette cameo beginners is that their cameo 3 autoblade is cutting through the vinyl or other material and the backing. Once the vinyl is removed look at your test cut. Silhouette finally has more autoblades available and is sending me a new one.

Place the vinyl onto the silhouette cutting mat with the backing paper side down onto the mat making sure the vinyl is covering the same area where the design is placed on the virtual mat in silhouette studio. Can the triangle be removed completely without any places sticking. In most cases there are two quick fixes that will fix the issue and get you cutting successfully in a hurry. For me this is the bane of using vinyl.

Did the machine cut all the way through to the back.